How to Apply a Screen Protector

posted Jan 17, 2012 3:57 AM by Erez Kalman [ updated Jan 17, 2012 4:01 AM ]

Turn your device OFF and remove the battery (if possible) and close the battery compartment protector

Make a placement solution:

In a clean bowl: fill with water (distilled if possible) and add 1-2 drops of dish washer soap (I recommend to use brands that do not add moisturizer's), mix well and put in a new clean spray bottle.

your hands with soap and dry them

onto fingertips

protective cover from screen protector

screen protector in one hand and spray adhesive and non adhesive side - Caution! DO NOT SPRAY YOUR DEVICE!!

screen protector to the device, adhesive side towards the screen/device, and slide into place

using a squeegee (or any stiff PLASTIC card), push the excess moisture and any bubbles away from the center towards the edges, and away from any open or uncovered ports

soak up any excess moisture with a lint-free cloth(recommended) or paper towel

For best results: Allow 12-24 hours for the screen protector to properly set

Notes:

1) The images in this page were taken from Zagg however this site and this page/instructions are not endorsed or affiliated with Zagg in any way.

2) Zagg has their own special solution which they call SHIELDSpray™ which is made of >99% water and the rest are substances mainly used in soaps (see attached MSDS).

v.1

1200673_MSDS.pdf

(30k)

Erez Kalman,

Jan 17, 2012 3:57 AM